 |
 |
|||||||
 |
||||||||
|
||||||||
 |
||||||||
|
||||||||
BRACKETS |
||||
| Installation and Extension | ||||
The key to the complete system is ease of assembly by using the range of standard brackets and mountings, plus the provision of T Slots in the extruded track section upper flange, to allow the use of captive nut fasteners. The three slots give unlimited scope for positioning of suspension brackets and mounting locations. This also provides easy mounting of ancillary equipment such as collector rails, catenary systems, electrical equipment, air lines and fittings. A full range of structural brackets is available to easily and safely install and support the complete system. All that is required is a single spanner and an electric drill. The system, being lightweight and modular, can be quickly and easily installed allowing for future modification, extension or relocation. All brackets and fixtures are zinc plated for corrosion resistance. Fasteners are grade 8.8 Brackets and Mountings are supplied complete with rivets (where necessary) bolts, nuts and washers. All Bomac Engineering products are compliant with Australian safety codes, including Australian Crane Code AS1418. |
 |
|||
 |
The universal beam clamp (shown left) allows Altrac rails to be connected to standard I-beams of varying thicknesses. Altrac lengths can be fit together quickly and easily using the extension kit shown below. This helps make installation or future system extension simple. No special tools or welding are required.
|
|||
|
||
|
 |
|
